Saturday, 21 January 2017

SMD rework station

2 in 1 SMD Soldering Hot Air Rework Station + Stand 3 Nozzle 5 Tips 852d+ Iron Mark Ethan



I have been repairing motherboards and other chipsets of computers for two years now.

These badass chips are very much repairable when you know how to repair them.




SMD chipsets can be very hard to remove with a normal soldering gun. That's why I have been using this master gun for removing SMD components like mosfets, caps, VRM circuits and almost all the small components inside of a mother board.

Many people think that motherboards are not repairable when it comes to bad chips or caps. I have been doing this thing for two years and have repaired lots of them. 70% chances of a mother board getting repaired is not that bad right???




This rework station is used to remove and place chip and other small components which can get damaged if removed using a normal gun.

Operating on high heat and smooth work, I have been using this framework since the last 6 months and has been a good co-worker for me. I love it. 




Thought you guys want to know....

About the gun - 

Mark Ethan- Samsung Chip Microcomputer Control- Very Fast Heat Up process & Stable Temperature

Sensitive Components Protected by ESD Design Of Soldering Iron. Simple To remove and replace tips




Adjustable air flow and temperature control for stop rotation. 6 Tips + 3 Nozzle + IC pick included

Large LED Displays give accurate display of temperature of hot air gun and Iron.


Samsung Micro Computer control built in for very quick warm up. Stable and accurate temperature control. Amount of airflow does not impact temperature Soldering Iron. The Hot Air Gun can be used at the same time or independently as the user needs.




High end ESD design protects sensitive components

Lead Free Soldering 28L Diaphragm pump Adjustable temperature control and Airflow Great For -Pre-heating, lacquer removal, glue soldering, heat shrinking, ice out viscosity removing.




Plastic Stand included with sponge to keep hot iron safe, metal stand to keep hot gun safe.

Samsung Microchip design allows cool airflow to dramatically extend the life and safe operation of the product

Great for PLCC, QEP, BGA, SOIC, Chip and other components sensitive to temperature Dimensions 5'' X 8" x 11" 110v 50/60HZ




Includes Important Safety Note- REMOVE THE RED METAL PROTECTIVE SCREW at the bottom of the station before using - the screws are only there to protect the unit in transportation - it needs to be removed failure to remove can short out the hot air.

Hot Air Gun Spec: Air flow volume: 24-30L/Min Temp. Control: 100-500 degree C Temp. Stability: +/-2 degree C Power consumption: 550W Air pump type: Diaphragm pump Soldering Iron Spec: Power consumption: 60W Temp. Control: 100-500 degree C Temp. Stability: +/-2 degree C Heater Material: Nichrome List of included components Main Soldering Station/ Hot Air Gun/ Hot iron included- 3 nozzles included, steel holder included 6 iron tips - 5 in the bag and 1 already installed in the iron. Plastic stand with sponge reinforced IC Extractor steel holder




Iron temp- 212- 900 degrees F Hot Air Temp - 212 - 932 F 
All temp readouts are in Celsius










Other posts - 


No comments:

Post a Comment